Skip to content
BuyOnceRight: buy once, buy right
License Plate Covers · How-to guide

How to Install a License Plate Cover: Step-by-Step Guide

Installing a license plate cover takes 5-10 minutes with a screwdriver. This guide covers the tools needed, removal of the old plate, correct screw torque, and tips for preventing future cracking.

On this page
What matters

Key decision factors

Step 1: Remove the Existing Screws

The standard license plate has two or four mounting screws. Turn counterclockwise to remove.

Step 2: Remove the Old Plate and Cover

Slide the plate free from the mounting bracket. If there is an existing cover, remove it.

Step 3: Install the New Cover

For snap-over covers: align the cover over the plate face. Snap the corner clips into place.

Step 4: Reinstall the Plate

Position the plate and cover together over the mounting holes. Thread screws by hand to align, then tighten with the screwdriver.

Step 5: Check Visibility

After installation: stand at a normal distance and verify all characters are fully visible through the cover. Any cover that obscures any character creates a legal issue regardless of intent.

Step 1: Remove the Existing Screws

The standard license plate has two or four mounting screws.

Turn counterclockwise to remove.

If the screws are rusted or frozen: apply penetrating oil (WD-40 original) and wait 5-10 minutes before attempting removal.

Forcing a stuck screw strips the head, once stripped, removal requires a screw extractor bit.

If the screws turn but do not release: some vehicles use pop rivets or clips behind the bumper.

Step 2: Remove the Old Plate and Cover

Slide the plate free from the mounting bracket.

If there is an existing cover, remove it.

Inspect the mounting bracket and bumper for corrosion or damage.

Step 3: Install the New Cover

For snap-over covers: align the cover over the plate face.

Snap the corner clips into place.

The plate should be held firmly against the cover back without rattling.

For frame-style products: slide the plate into the frame channel, or position the frame around the plate perimeter.

Step 4: Reinstall the Plate

Position the plate and cover together over the mounting holes.

Thread screws by hand to align, then tighten with the screwdriver.

Hand-tight plus a quarter-turn is sufficient.

Overtightening causes cracking at the screw holes.

If the cover includes rubber washers, use them, they cushion the mounting point and prevent stress cracking.

Step 5: Check Visibility

After installation: stand at a normal distance and verify all characters are fully visible through the cover.

Any cover that obscures any character creates a legal issue regardless of intent.

Best License Plate Covers - top cover picks License Plate Cover Cracking Fix - avoiding cracks Are License Plate Covers Legal?

Put it into practice

Top license plate covers we recommend

See all
Answers

Frequently asked questions

What size screws do license plates use?

Standard US license plates use 1/4-20 screws or 6mm metric screws depending on the vehicle make. Most plate frames and covers include the correct screws. Older vehicles may have #14 sheet metal screws. If the included screws do not fit, take an existing screw to a hardware store to match the thread.

Do I need to remove the plate to install a license plate cover?

Yes, for a full-face cover that snaps over the plate. The plate must be removed to place the cover behind the plate. For frame-only products that mount over the face without covering it, you only need to remove the screws to slide the frame over the plate.

Keep researching

Related guides & best picks